Atmega8 16AU Programming Problem

Posted in the Atmel Forum

Comments

Showing posts 1 - 3 of3

Brian

Sydney, Australia

Hi, I am using the AVRISP mkII usb programming module to program the Atmega8 16AI with no problems. Recently we received the Atmega8 16AU, which is the pb alternative, & cannot seem to program them. The programmer does not recognise the part.
I have upgraded AVR Studio to the latest version & flashed the AVRISP mkII to the latest firmware (v1.06)
Has anyone seen this before?

legi0n

Vancouver, Canada

worst case: burnt chip
best case: incorrect set fuses in the new chip preventing it to start the resonator.(google atmega fuse recovery)

Rent A Coder

Receive an average of 5-6 qualified bids within
just 24 hours. Over 10,000 registered coders
are waiting to bid on your project.
Let a skilled coder finish the project for you.
http://www.programmingcoder.com

	Tell me when this thread is updated!
	(registration is not required)

Showing posts 1 - 3 of3

Type in your comments to post to the forum

Name
(appears on your post)

Comments

Type the numbers you see in the image on the right:

Please note by clicking on "Post Comment" you acknowledge that you have read the Terms of Service and the comment you are posting is in compliance with such terms. Be polite. Inappropriate posts may be removed by the moderator. Send us your feedback.

Other Recent Atmel Discussions

Topic	Updated	Last By	Comments
Hotdiscussion	Oct '09	Sisty	1
problems on AT86RF212	Jul '09	slowey	1
at91sam9263-ek	Jun '09	chal	1
ATF22V10 combinatorial output with buried register (Dec '08)	Dec '08	Bryn Wolfe	1
Atmega128 config bits (Nov '08)	Nov '08	avrnewb	1
MCU, Asia spell the difference for Atmel (Sep '08)	Sep '08	frankie	1
writing to 93c46 serial EEPROM (Sep '08)	Sep '08	mylog	1