Multiple Load Cases
Ospi

Melbourne, Australia

#1 Jul 2, 2013
Hi all,

I am quite new to this software and beginning to run some basic analysis. Currently I am looking at a fatigue case on a rotating disc which is also being pulsed back and forth along its axis. To test this I am looking at setting up two load conditions within the analysis so that I can run solution combination non-proportional fatigue analysis on both the rotating and acceleration forces acting on the disc.

However I am unsure how to get more than a single load case into the analysis. Below is an example picture I found online and you can see there are two "environments" and I am wishing to achieve the same but am not show how to do so. Any advice?

Cheers!

[img]http://img706.imageshack. us/img706/6428/x3k.png[/img]

Tell me when this thread is updated:

Subscribe Now Add to my Tracker

Add your comments below

Characters left: 4000

Please note by submitting this form you acknowledge that you have read the Terms of Service and the comment you are posting is in compliance with such terms. Be polite. Inappropriate posts may be removed by the moderator. Send us your feedback.

ANSYS Discussions

Title Updated Last By Comments
Contraction test on ansys Dec 20 bert 1
Where to find the cohesion value of metal in AN... (Jun '09) Dec '16 tuanpvan 2
Problem of non transfer of stress in ansys stru... Dec '16 Akarsh 1
ANSYS Workbench : How to measure angle when usi... Dec '16 naz 1
Geotechnics: Modelling of geotextile in embankm... Dec '16 Reza 2
Loading and Unloading Pressure Nov '16 ANSYSWORKBENCHKMCL 1
Safety Factor on a layered section (Apr '13) Nov '16 Nardomonas 3
More from around the web