Ansys 13,14 errors
Rasmus R

Tallinn, Estonia

#1 Feb 21, 2013
Hello

I have a big(little) problem. My licence is okey i think...but when i open my workbench and want to edit geometry, model..etc it reports ansysWBU.exe encountered a error...a diagnostic file has been ......blabal. And then error window pops out: the geometry editor session was abnormally closed.

Any ideas ?
Sincerely
Rasmus
Mohamed Elsakka

Sheffield, UK

#2 Apr 6, 2016
I uninstalled the Graphic Card Driver and before restarting the PC, I searched for (Device installation setting) in start menu and disabled it then every thing work properly.
That will retain the basic display driver.
However this solution may affects other programs and features that need the Graphic Card Driver.
Regards,

Tell me when this thread is updated:

Subscribe Now Add to my Tracker

Add your comments below

Characters left: 4000

Please note by submitting this form you acknowledge that you have read the Terms of Service and the comment you are posting is in compliance with such terms. Be polite. Inappropriate posts may be removed by the moderator. Send us your feedback.

ANSYS Discussions

Title Updated Last By Comments
Contraction test on ansys Dec 20 bert 1
Where to find the cohesion value of metal in AN... (Jun '09) Dec '16 tuanpvan 2
Problem of non transfer of stress in ansys stru... Dec '16 Akarsh 1
ANSYS Workbench : How to measure angle when usi... Dec '16 naz 1
Geotechnics: Modelling of geotextile in embankm... Dec '16 Reza 2
Loading and Unloading Pressure Nov '16 ANSYSWORKBENCHKMCL 1
Safety Factor on a layered section (Apr '13) Nov '16 Nardomonas 3
More from around the web