Base excitation Problem

Base excitation Problem

Posted in the ANSYS Forum

SWAPNA

Columbus, IN

#1 Nov 18, 2011
Hello all,
This is my 1st post on this forum.
I am struggling with one problem.
I have done actual testing of a fixture on vibration table.
where I have checked g level at various points of fixture with the help of accelerometers.
I had vibration table excited from 0 - 80 Hz, sine wave, 1g acceleration.
I did this testing in X and Z direction.
I now want to simulate this testing in Ansys.
How should I do that?
Plz help.
SWAPNA

Columbus, IN

#2 Nov 18, 2011
Also, my aim from this project is to prove that Fixture do not alter the g level given from table (Base) and hence component on fixture is not under/over tested.

Tell me when this thread is updated:

Subscribe Now Add to my Tracker

Add your comments below

Characters left: 4000

Please note by submitting this form you acknowledge that you have read the Terms of Service and the comment you are posting is in compliance with such terms. Be polite. Inappropriate posts may be removed by the moderator. Send us your feedback.

ANSYS Discussions

Title Updated Last By Comments
topology optimization code_ansys apdl May '17 ju_ange 1
ansys apdl_derivatives May '17 ju_ange 1
Ansys APDL- problem with spring (Feb '17) Feb '17 Anonymous 2
Structural Calculation (Jan '17) Jan '17 genry 1
ANSYS DesignModeler (Jan '17) Jan '17 VSt12 1
Contraction test on ansys (Dec '16) Dec '16 bert 1
Where to find the cohesion value of metal in AN... (Jun '09) Dec '16 tuanpvan 2
More from around the web