Need some help on my net-net 9200

Need some help on my net-net 9200

Posted in the Acme Packet Forum

Michael NWR

Portland, OR

#1 Mar 5, 2013
I have two SPU installed into my net-net 9200 one of then I am able to boot all the way up to a login prompt and login and then I get the following "** EMERGENCY ALARM ** Ready Timeout on slot 1" error message after about a minute and the system reboots and then stops at:

Spawning Task tLEM prio=100 opts=0x1000000 stack=32768
Starting lem (D5.0.0p8)-c 1 0 0
[email protected] started

I have let the system set for a bit to see if it will get past the above but it never does.

If I power off and swap the SPU cards I get either the following over and over again.
connect: errno = 0x3c
XFER transfer error.
Retrying CPU0...

or

Retrying CPU0...
FTP transfer error.


any help would be most appreciated

Tell me when this thread is updated:

Subscribe Now Add to my Tracker

Add your comments below

Characters left: 4000

Please note by submitting this form you acknowledge that you have read the Terms of Service and the comment you are posting is in compliance with such terms. Be polite. Inappropriate posts may be removed by the moderator. Send us your feedback.

Acme Packet Discussions

Title Updated Last By Comments
Acme Packet Exams (Feb '14) Feb '14 Tom 1
CUCM 9.1 integrate with ACME SBC 4250 (e164 is ... (Jan '14) Jan '14 vishnu 1
More from around the web