Comments
1 - 1 of 1 Comments Last updated Feb 20, 2011
Jsin

AOL

#1 Feb 20, 2011
One morning when I went out to start my jeep, it would turn over but would not fire. I noticed that as I turned the ignition forward but not over I could not hear the fuel pump engage. I replaced the fuel pump, but still have the SAME EXACT PROBLEM!!! When I hooked up the scanner, i received a message " not able to connect/link to vehicle. It said "check connection to data link connector and make sure key is turned forward then scan again." I checked all and found it was all connected and the key was in the right position and scanned again to see the SAME MESSAGE. Does anyone have any idea from best to worst case what the problem could be? Any and every possible fix or even ideas of whats causing this will be GREATLY appreciated. Thank you all very much...PLEASE HELP!!!

Tell me when this thread is updated: (Registration is not required)

Add to my Tracker Send me an email

Add your comments below

Characters left: 4000

Please note by submitting this form you acknowledge that you have read the Terms of Service and the comment you are posting is in compliance with such terms. Be polite. Inappropriate posts may be removed by the moderator. Send us your feedback.

Jeep Wrangler Discussions

Title Updated Last By Comments
Here's Why Chrysler's Sales Boom May Not Last Jun '14 8.3 1
The Bronco Trolls On! Ford's Muscular Troller T... Jun '14 mr goodwrench 1
Wrangler will not shift into drive. (Mar '13) Apr '14 Connie 3
Jeep CJ Edition - Sideways Mar '14 BrainJuice 1
Chrysler to take over supplier-run Toledo Jeep ... (Nov '10) Feb '14 wrangler paint hours 1,622
Detroit Auto Show: Chrysler Group's Mopar To Ha... (Jan '14) Jan '14 Bensley reality 1
2000 wrangler (Sep '13) Sep '13 paul 1

Buy a New Car


Zipcode:
•••
Enter and win $5000
•••

Jeep Wrangler People Search

Addresses and phone numbers for FREE

•••